Powering Up

*Once the connections have been completed (p. 10), turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.

Power to the various devices should be turned on in the appropriate order. First, turn on the units from which MIDI messages will originate (computer, PC-70). Next, turn on the sound module, then the audio reproduction equipment. This unit’s power switch [23] is located on its rear panel.

Power off your system in the reverse order.

*This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

Setting the MIDI Channel (MIDI Transmit Channel)

To control the sound module, set the MIDI channel the PC-70 will use to transmit on to the same channel the module is using to receive on. If the sound module is multitimbral, set the channel on the PC-70 so it matches the MIDI channel of the Part in the module that you wish to control.

fig.MidiCh.e

MIDI Channel

[Procedure]

1.Press MIDI/SELECT [3] (LED will show “SEL”).

2.Select the MIDI channel by pressing one of the 16 keys in the MIDI channel section [6].

3.Press MIDI/SELECT [3] again to confirm your selection.

12

Page 12
Image 12
Roland PC-70 owner manual Powering Up, Setting the Midi Channel Midi Transmit Channel, Procedure