INSTALL | RANGE |
|
|
| |||
BE SURE RANGE BRANCH CIRCUIT IS DE- |
|
| |||||
ENERGIZED. |
| I | IMPORTANT SAFETY WARNING | ||||
1. Remove Oven | Door | ||||||
| Be sure to attach range to counter and | ||||||
| Open | the door | to the stop position | (see illustration). | |||
n | be sure counter | top is securely attached | |||||
l | Grasp | the door | at each side and | lift up and off the | to the cabinets | or wall. | |
| hinges. |
|
| A Failure to do so could permit the range | |||
NOTE: | When the | door is removed | and hinge arms are at | ||||
to tip, causing | injury. | ||||||
stop position, do not bumportry to move the hinge arms. The |
|
|
hinges could snap back causing injury to the hands Or damage to the porcelain on the front of the range. Cover the hinges with toweling or empty towel rolls while working in the oven area.
STOP | POSITION |
To replace: | VENT TRIM |
l
l
Hold the door over the hinges with the slots at the bottom edge of the door lined up with the hinges. The hinge arms must still be in the stop position.
Slide the door down onto the hinges as far as it will go and close the door.
2. Position range in opening.
l
l
Raise
Drill 118” diameter pilot holes into countertop using holes in upper side panels. Attach range to countertop (Fig. 4) with screws provided in literature package.