Rose electronic Professional Series manual Operation, Selecting a computer

OPERATION

Selecting a computer

To connect to a computer, you can select it from the UltraView Pro’s front panel, select it by keyboard commands, select it through the RS232 serial port, or you can select the computer from a computer select window as shown in Figure 10.

Selecting a computer from the front panel

Using the + and – buttons on the front panel will advance (+) or switch to the previous (-) computer port.

Selecting a computer using keyboard commands

Press and release the left control <Ctrl> key, then enter the computer port number. Pressing and releasing the left control <Ctrl> key then the “+” or “–“ key will advance forward or backwards one sequential port.

Selecting a computer through the RS232 port

Selecting a computer can be done through the RS232 port if needed. Contact Rose Electronics Technical support for details.

Selecting a computer using the Computer select window

Press and release the left control <Ctrl> key, then press Esc. The computer select window will display. Use the up/down arrow keys and select the computer to switch to and press enter. You will be immediately connected to that computer. Use the page up/down keys if there are more than 16 computers in your system.

Computer select window

1→ Computer		1
2	Computer	2
3	Computer	3
4	Computer	4
5	Computer	5
6	Computer	6
7	Computer	7
8	Computer	8

Figure 10. Computer select window

26ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL