48 |
|
Miscellaneous Settings
Other Options
����������������������
����������
�����������������������
���������������������
��������������������
������������������������
������������������������
�������������������
�����
�����
��������������
This OTHER OPTIONS menu, accessed from the MAIN menu, provides access to several miscellaneous settings as follows:
RECORD: Select which source signal to be sent to the recording outputs
by choosing one of the input sources. The options are: CD, TAPE, TUNER, VIDEO
TURN ON VOL: Specifies a default volume level to be used each time the unit is activated. You can select LAST to have the receiver power up with the last previously used volume setting. Or, you specify a volume from MIN (full mute) to MAX, in 1dB increments. Note that this setting cannot exceed the MAX VOL established in the next line of the menu.
MAX VOL: Specifies the maximum volume level for the receiver. The volume cannot be adjusted above this level. Settings range from MIN to MAX, in 1dB increments.
POWER: This setting determines how the receiver powers up.
With the default STANDBY setting, the unit powers up in standby mode when AC is applied and the rear panel POWER button is ON. The unit must be activated using the front panel STANDBY button or the remote ON/OFF buttons.
With the DIRECT setting, the unit is fully activated when AC power is applied and the rear panel POWER button is ON; however, it may be put in standby mode using the front panel STANDBY button or the remote ON/OFF buttons.
In
In RESUME mode, the receiver will return to the last power condition setting when switched on. For example, when the AC mains power is switched OFF during operation, it will return to operating mode when the mains power is switched on again.
LANGUAGE: Selects a language for the On Screen Display
DISCRETE: The default setting of NO allows control of volume and input selection in remote zones
The discrete option does not affect the control of the zones from the front panel buttons in any way.
Note: The DISCRETE function is not available on all models and is dependent on the software version installed. The DISCRETE function is intended for use by a Rotel dealer or installer only.
Rotel’s use of discrete IR commands in
Go to ‘Support’ for downloads and technical updates, or seach for ‘discrete’ to find relevant items. Remote commands are available in Philips Pronto CCF format and in RTI CML format at:
www.rotel.com/downloads/prontocodes.htm
www.rotel.com/downloads/rticodes.htm
Change settings on the OTHER OPTIONS menu by highlighting the desired line using the UP/DOWN buttons and using the +/– buttons to step through the available settings. To return to the MAIN menu, press the ENTER button. Press the MENU/OSD button on the remote to cancel the display and return to normal operation.
Video/HDMI Setup
��������������������
�����������
������������������������
���������������������������
�������
�����
����
�����
��������������
The VIDEO/HDMI menu deals with the configuration of the HDMI and Component output for
VIDEO OUT FORMAT: Specifies the video resolution and format of the video output at the TV MONITOR outputs. The receiver will scale all video inputs up to this specified resolution for a perfect match with the native resolution of your HDTV monitor. Can be 480p/576p, 720p, 1080i, 1080p.
HDMI AUDIO MODE: options are AMP MODE and TV MODE. In AMP MODE the HDMI Audio and other audio (analog or digital) inputs are processed and amplified by the receiver for output to the connected speakers. TV MODE
27/8/08 14:22:28
