RTS SSA-424A Wire Call Signal Connections, Call Signal Connection for ADAM, Adam CS, and Zeus

Installation

NOTE: TW systems must provide termination on the audio channel.

Balanced Configuration

Pin 1	No Connection
Pin 2	Balanced Audio + Input/Output
Pin 3	Balanced Audio - Input/Output

** Termination 300 Ω

If your intercom system is equipped with a UIO-256 (Universal Input/Output) Frame, you can also use that for connections (Table 2 on page 10 and Table 3 on page 10).

As an alternative to using the GPI, you can use external components to send and receive call signals as described in “Call Signal Connections for other 4-wire Communications Systems” on page 11.

There are two possible configurations for unbalanced connection:

Unbalanced Configuration 1

Pin 1	Audio Common
Pin 2	Audio Input/Output
Pin 3	No Connection
** Termination 200 Ω
Unbalanced Configuration 2
Pin 1	Audio Common
Pin 2	No Connection
Pin 3	Audio Input/Output

**Termination 200 Ω

2.On the SSA-424A front panel, set the CHAN SEL switches as follows:

•Balanced Configuration: set the CHAN SEL switches to the BAL position.

•Unbalanced Configuration 1: set the CHAN SEL switches to position 1.

•Unbalanced Configuration 2: set the CHAN SEL switches to position 2.

Typical GPI connections are shown in Figure 5 on page 9. The example uses GPI outputs #1 and #2 and GPI Input #1. You may substitute other GPI Input and Outputs.

IMPORTANT NOTE FOR AZEDIT USERS: AZedit version 1.06 or higher includes a feature which allows you to invert the action of the GPI outputs. By default, these output are set to duplicate the action of the RTS FR9528 Relay Frame accessory. This is the correct setting for use with the SSA-424A. To check the AZedit setting, select Intercom Configuration in the Options menu. Click on the Options tab, then verify that Configure onboard GPI outputs in FR9528 mode is selected.

NOTE: If System A or System B will not be used, set the 2W CHAN SEL switch to the OFF position and attach a dummy load to the TW XLR connector.

4-Wire Call Signal Connections

NOTE: These connections require the call signal option.

Call Signal Connection for ADAM, ADAM CS, and Zeus

You can use the General Purpose Interface (GPI) connector to interface call signals. The pin-out of the connector is the same for all of these intercom systems Table 1 on page 9.

ADAM GPI Connector: XCP-ADAM-MC, J11

ADAM CS GPI Connector: J903

Zeus GPI Connector: J27

8