Rubbermaid 5L20 Floor Installation, Wall Panel C Installation, CAUTION Do not overtighten screws

Models: 5L20

1 18

Page 5

a. Connect and align Repeat Floor (B) to Front Floor (A) and install Screws (AA) 9 places; keep panels aligned and even while installing screws.

HELPFUL HINT: Pilot holes may be drilled for the screws using a 1/8" drill bit.

AA (9)

3.0Wall Panel C Installation B

Using a screwdriver, punch out the screw holes on the top of Repeat Left Side (C) 2 places.

Image 5

Contents

Installation Steps Department can accurately and quickly assist you if necessaryBEFORE YOU BEGIN - PREASSEMBLY 5L205L20 PREASSEMBLYMATERIALS OR CLEANING TOOLS CAUTION Always use eye protection/safety glasses during assembly1.0 Site Preparation CAUTIONS4 places on Front Floor A Floor Installation8 places on Repeat Floor B of Repeat Floor B3.0 Wall Panel C Installation 2.1 Floor InstallationCAUTION Do not overtighten screws Screw Holesclick ALIGN 3.1 Wall Panel D Installation ab. Snap Repeat Left Side C into the back position of Repeat Floor B ALIGNclick 3.2 Wall Panel E InstallationHELPFUL HINT Lubricate dovetails with liquid soap b. Connect Left Back D into dovetails of Repeat Left Side Cb. Snap Repeat Right Side E into the back position of Repeat Floor B 3.3 Wall Panel F InstallationclickALIGN click click Install Wall ConnectorsDclick 3-3E VIEWSAlign the lap joint between Repeat Left Side C and 3.4 Wall Panel G InstallationNote This pilot hole is to be drilled through both walls Screw Holesclick 3.5 Wall Panel H Installation aclick d. Snap Front Left Side G into Front Floor ASnap Front Right Side H into Front Floor A clickclick 4.0 Roof Panel M back position Installation Page 4.2 Roof Panel J front position & Door Installation click Install Roof Pins four places1. Insert pin in slot 3. Rotate head flush with roof5.1 Door Finishing Installation 5.0 Finishing Installationclick HELPFUL HINT Pilot holes may be drilled for the screwsCustomer Service MAINTENANCE & SAFETY