Ruby Tech GS-1224L manual Managing 24-Port GbE Web Smart Switch through Ethernet Port, User Manual

User Manual

2-1-3-1. Configuring Management Agent of 24-Port GbE Web Smart Switch through Ethernet Port

There are two ways to configure and monitor the switch through the switch’s Ethernet port. They are Web browser and SNMP manager. The user interface for the last one is RubyView dependent and does not cover here. We just introduce the first type of management interface. Web-based UI for the switch is an interface in a highly friendly way.

24-PORT GBE WEB SMART SWITCH

Default IP Setting:

IP = 192.168.1.1

Subnet Mask = 255.255.255.0

Default Gateway = 192.168.1.254

Ethernet LAN

Fig. 2-6

Assign a reasonable IP address, For example:

IP = 192.168.1.100

Subnet Mask = 255.255.255.0 Default Gateway = 192.168.1.254

•Managing 24-Port GbE Web Smart Switch through Ethernet Port

Before you communicate with the switch, you have to finish first the configuration of the IP address or to know the IP address of the switch. Then, follow the procedures listed below.

1.Set up a physical path between the configured the switch and a PC by a qualified UTP Cat. 5 cable with RJ-45 connector.

Note: If PC directly connects to the switch, you have to setup the same subnet mask between them. But, subnet mask may be different for the PC in the remote site. Please refer to Fig. 2-6 about the 24-Port GbE Web Smart Switch default IP address information.

2. Run web browser and follow the menu. Please refer to Chapter 4.

Publication date: March, 2007

Revision A1

15