Runco SP-42DHD, SP-60DHD, SP-50DHD manual RS-232 Controller, Connection

Installation

Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation					RS-232 Controller
system (if present) to the RS-232 Control port on the DHD Controller; see Figure 3-9.					Connection
For more information about using this connection, refer to Serial Communications on
page 53.
5	4	3	2	1

			TRIGGERS
		1	2	3	IR
Pb	Pr	Y	S-Video 1
	Component Video	Video	S-Video 2	RS-232 Out	RS-232 Control

9 8 7 6

2Transmit Data

3Receive Data

5Ground

(none of the other pins are used)

to Automation/ Control System or PC

Figure 3-9. RS-232 Control System Connection

If your home theater contains equipment that responds to 12-Volt triggers, connect it to the 12-Volt trigger outputs as shown in Figure 3-10.

Connecting 12-Volt

Trigger Outputs to

External Equipment

			TRIGGERS
		1	2	3	IR
Pb	Pr	Y	S-Video 1
	Component Video	Video	S-Video 2	RS-232 Out	RS-232 Control

3.5-mm mini plug

to 12-Volt	Sleeve = Ground
trigger-activated
	Tip = +12V
equipment

Figure 3-10. Connecting 12-Volt Trigger Outputs

PlasmaWall SP Series Owner’s Operating Manual 29