Use the Service menu to access advanced display configuration settings. This menu should be used by
You must enter a passcode to access the Service menu.
Note
Test Video: Select Test Video from the Service Menu to access the internal test patterns on the PlasmaWall. Four patterns are available, consisting of white/gray or colored bars. These are useful for calibrating other theater source components (DVD player, HD tuner etc.) that have their own picture controls.
Press MENU to exit test pattern mode.
Input Names: You can give each DHD Controller input a descriptive name. For example, you may want to change the default input name to the type of source component connected to it: “VCR,” “DVD,” “Laptop” et cetera. Composite,
To edit an input name, select Input Names from the Service menu. Press 
or 
to select an input and press ENTER. Use the 
or 
buttons to change a character; press 
or 
to select a character to change. When you have finished editing the input name, press MENU.
To restore the default input name, press 
repeatedly to highlight that input name in the “Restore” column. Then, press ENTER.
To save input names so that they can be restored after a System Reset (described on page 47), press 
repeatedly to highlight “Save.” Then, press ENTER.
The 
button takes you from top to bottom in the left column, then
Note from top to bottom in the right column. To highlight “Save,” scroll through both columns.
Remote Control: The Remote Control menu shows you the primary and secondary infrared (IR) codes to which the DHD Controller will respond. By default, both are set to
17. You can change these codes if either:
•Another device in the theater (a DVD player, for example) is responding to commands from the DHD Controller remote control (Figure
•You have multiple DHD Controllers and want to control them independently, as opposed to broadcasting commands from a single remote to all of them. In this scenario, you can use multiple remotes programmed to use different IR codes. Or, you can use a single remote and change the IR code as needed to address a specific device.
Use the DHD Controller
Tip Then, change the code sent by the remote to match as described below.
Service
Service
Test Video
Input Names
Remote Control
Analog Out Mode
Display Device
HD Format
Triggers
Miscellaneous
Resolution
System Reset
Restore Saved Settings
Input Names
| Restore |
Composite | Composite |
|
|
Component SD | Component SD |
HD/RGB 1 | HD/RGB 1 |
HD/RGB 2 | HD/RGB 2 |
DVI 1 | DVI 1 |
DVI 2 | DVI 2 |
Save |
|
PlasmaWall SP Series Owner’s Operating Manual | 45 |
