Runco SP-42DHD / SP-42DHDXA manual RS-232 Connection from the DHD Controller to the PlasmaWall

Installation

Digital Video Connection: The PlasmaWall has a DVI input, labeled DIGITAL RGB.

Connect the DVI output from the DHD Controller to this input, using a standard DVI cable.

RGBHV Connection: Connect the RGBHV output from the DHD Controller to the ANALOG RGB IN input on the PlasmaWall. Use a standard, RGBHV breakout cable with five BNCs at the DHD end and a 15-pin, D-sub male connector at the PlasmaWall end.

RS-232 Connection: Connect the RS-232 output from the DHD Controller to the

RS-232Cinput on the PlasmaWall. Use a standard, modular telephone cable with RJ11 plugs at both ends. On the PlasmaWall end, use the provided RJ11-to-DB9 adapter. This adapter is wired as shown in Figure 3-4.

	4	XMT DATA		RCV DATA	3	PlasmaWall
	3	RCV DATA		XMT DATA	2	1	5
		SIG GND		SIG GND
To/From	2, 5				5
DHD				REQUEST TO SEND		6	9
Controller					8
				CLEAR TO SEND		RS-232C
					7
	1, 6		NO CONNECTION
					1, 9

DB-9 Female

RJ-11 Male

Figure 3-4. RS-232 Connection from the DHD Controller to the PlasmaWall

24 PlasmaWall SP Series Owner’s Operating Manual