Runco SP-42DHD / SP-42DHDXA, SP-50DHD / SP-50DHDXA Service/Setup Menu, Video NR Noise, Reduction

PlasmaWall Service Remote Control

For the vast majority of installations, the DHD Controller remote control gives you all the control you need over display quality settings. However, there are two settings internal to the PlasmaWall that can improve the displayed image quality on INPUT 1: VIDEO NR (noise reduction) and MPEG FILTER. These settings can be found in the Setup Menu, shown in Figure A-2.

PLASMAWALL		INPUT 1
PICTURE SCREEN		SET-UP OPTION
	COLOR TEMP.	: MIDDLE
	AUTO OFF	: OFF
	VIDEO NR	: MIDDLE
	MPEG FILTER	: LOW
	CHROMA EE	: ON
	FILM MODE	: OFF
	COLOR SPACE	: RGB
	SIGNAL	: 720p
SET SET		MENU EXIT

A.2

Service/Setup Menu

Figure A-2. PlasmaWall Setup Menu
To apply Digital Noise Reduction (DNR) to the input signal, select Video NR from the	Video NR (Noise
Set-Up menu. Noise reduction is useful for improving the signal-to-noise ratio of video	Reduction)
signals.
To change the Noise Reduction setting on INPUT 1:

1.Press 1 to switch to PlasmaWall INPUT 1.

2.Press MENU on the PlasmaWall Service Remote Control.

3.Press or to select SETUP.

4.Press to select VIDEO NR, then press SET.

5.Press or to select the desired amount of noise reduction (OFF, LOW, MIDDLE or HIGH).

6.Press SET to confirm your selection.

PlasmaWall SP Series Owner’s Operating Manual A-3