Runco VX-22I operation manual VX-22i Rear Panel

2.2

VX-22i Rear Panel

Figure 2-2shows the VX-22i rear panel.

16 15 14 13

HD3 (VGA / Y-Pb-Pr)

Pr)-Pb-Y / (VGA HD3

HD2 (BNC)

(BNC) HD2

.cover lamp the off pull to screw the Remove

Remove the screw to pull off the lamp cover.

WIRED REMOTE

REMOTE WIRED

Service port. Not for user access

HD1 (RCA)

(RCA) HD1

SERVICE PORT

AUTHORIZED

PERSONNEL ONLY

L

L

2	4	6	8	10	12
1	3	5	7	9	11

Figure 2-2. VX-22i Rear Panel

1.LAMP COVER

Remove this cover to access the lamp compartment.

2.VACUUM FLUORESCENT DISPLAY (VFD)

Can be used instead of the OSD. Displays currently-selected menu or – if no menu is selected – the current source, input resolution and aspect ratio.

If an error condition occurs, a message	Please check issue(s)
appears here indicating the cause:
	Communication Error

3.RUN LED

–Lights blue to indicate that the projector is functioning normally.

–Flashes blue (one second on/one second off) to indicate an error condition.

–Flashes blue (one half-second on/one half-second off) for approximately 90 seconds after the system is turned off.

4.ISSUE LED

Lights red to indicate an error condition.

6 Runco VX-22i Installation/Operation Manual