Runco VX-22I operation manual Configure Lens Motor, Trigger, Adjust the Anamorphic

Configure Lens Motor ➤	CineWide with AutoScope maintains constant image height independent of the aspect
Trigger	ratio, while using the full display resolution of the projector. It accomplishes this by moving
	the anamorphic lens in front of the primary lens when widescreen material is being viewed.
	When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens
	moves out of the light path.
	To configure the lens motor trigger on the VX-22i for proper AutoScope operation:
	1.	Project a 2.35:1 aspect ratio test pattern or other image on the screen.
	2.	Press MENU on the remote control and enter the Service menu passcode.
	3.	Select Service from the Main menu.
	4.	Select Triggers from the Service menu.
	5.	Assign the trigger output to which the lens motor is connected to the Cinema and
		Virtual Cinema aspect ratios. This enables the lens motor to move the anamorphic
		lens into position (in front of the primary lens) when either aspect ratio is selected.
	6.	To save the trigger settings, press repeatedly to highlight “Save.” Then, press
		ENTER.
	7.	Select the Cinema aspect ratio to move the anamorphic lens into position, if it isn’t
		already. To do this, press CINEMA on the VX-22i remote control (Figure 2-4), or
		press or repeatedly with no menus visible on-screen.
Adjust the Anamorphic ➤	Adjusting the Horizontal (X) Lens Position:
Lens	1.	Project a white field on the screen.
	2.	Loosen the Yaw/X-Adjustment Levers underneath the lens.
	3.	Slowly move the anamorphic lens into place so that there are no shadows on either
		side of the screen:

Too Far Left

Correct position

Too Far Right

4.When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to secure the lens in place.

40 Runco VX-22i Installation/Operation Manual