Runco VX-22I operation manual Installing the Optional CineWide Lens Mount

3.5

Installing the Optional CineWide Lens Mount

Make sure to route the wire harness in its original position and away Caution from the moving lens stages and Motor Assembly, to prevent

unexpected disconnection or lens damage.

7.Lock the lens in place by turning the Lens Locking Nut (to the left of the lens)

180 degrees counter-clockwise. (Use a 6.0mm hex wrench.)

8.Replace the Lens Cavity Front Cover.

9.Reattach the Projector Front Jewelry by sliding the top down onto the two retaining dowels. Tighten the Phillips screw at the top of the projector to secure it.

10.Remove the Front Lens Cap.

If you are installing a standard (non-CineWide) VX-22i, skip this step and proceed with Mounting the VX-22i(page 27).

If you are installing a VX-22i/CineWide, proceed with Installing the Fixed CineWide Base Plate (VX-22i/CineWide)(page 26).

If you are installing a VX-22i/CineWide with AutoScope, proceed as follows to install the AutoScope lens motor.

1. Do not install the CineWide lens yet, only the fixed CineWide

Note base plate or AutoScope lens motor. You will install the CineWide lens after you install the projector and adjust the primary lens.

2.Some components shipped with your projector may differ slightly from what is shown in these instructions.

22 Runco VX-22i Installation/Operation Manual