
6. Serial Communications
To interface the
If you are using a PC to communicate with the VX-33i:
1.Start a terminal session on your PC using a
2.Configure the PC serial port as follows: no parity, 8 data bits, 1 stop bit and no flow control. Set the baud rate to 19200, to match that of the
3.Press <Enter>. You should see a command prompt (>) in the terminal window.
4.Type a command from among those listed in Table
•Commands are in ASCII format and are not
•For a command that takes no parameters, type the command followed by a carriage return; for example, to turn on the system, type ON<Enter>.
•For a command that takes a parameter, type the command, one or more spaces and the desired value followed by a carriage return; for example, to switch to the
•When you enter a valid command, the
•When you enter a misspelled or otherwise invalid command, the
•When you send a command followed by values outside the valid range for that command, the
•When the
•After sending an ON command, allow at least 30 seconds for the projector to warm up before sending another command.
6.1
6.2
Serial Command Syntax
Runco | 63 |