Runco VX-33I operation manual Quick Setup, Step Procedure For Details, Refer to

3.2

Quick Setup

Table 3-1gives a quick overview of the VX-33i installation process. The sections following this one provide detailed instructions.

	Note		Installation should be performed by a qualified custom video
			installation specialist.
Table 3-1. Installation Overview
Step			Procedure	For Details, Refer to
				page...
1		Choose a location for the projector		15
2		If installing a VX-33i/CineWide or VX-33i/CineWide		22
		with AutoScope: Install fixed CineWide base plate or
		AutoScope lens motor
3		Mount the projector		27
4		Connect signal sources to the projector		28
5		Connect external controller to RS-232 port (optional)		33
6		Connect 12-volt trigger outputs to AutoScope lens motor		34
		and/or other equipment (optional)
7		Connect projector and lens motor (if present) to AC power		35
		and power up
8		For rear-screen and/or ceiling-mount installations, select		36
		the proper picture orientation
9		Primary lens adjustments: projected image size (zoom),		17, 37
		position (shift) and focus
10		Install CineWide anamorphic lens (optional)		38
11		CineWide lens adjustments: position, pitch (angle),		40
		geometry and focus
12		Projector calibration: adjust the following for each input;		47
		save settings when finished:
		• Aspect ratio
		• Brightness
		• Contrast
		• Color level
		• Tint
		• Input position

14 Runco VX-33i Installation/Operation Manual