Russell Hobbs RHWM61200B - page 19

How to use

18

Child lock

•Child lock is used in order to protect the washing cycle from the effects of unwanted

button activations during the cycle. The Child lock is activated by pressing the Extra rinse

and Start/pause buttons on the control panel at the same for more than 3 seconds.

•When child lock is activated LEDs on the function buttons will flash to indicate that Child

Lock is active.

•When any of the programmes are running and the child lock is active, if another

programme is selected after programme dial is switched to the Stop position, the

programme already running will continue.

•In order to deactivate the Child lock, the same buttons, (Extra rinse and Start/pause),

should be pressed again for more than 3 seconds.

•Deactivation of Child lock is shown by flashing of the LED on the Start/pause button.

Important note

Your machine will inactivate the temperature and function buttons when the child lock is

activated.

For Customer Services & Spare Parts please call 0845 208 8750

Opening times: Monday - Friday 8am – 6pm & Saturday 9am – 1pm or visit

us at www.productcareuk.com

Contents

Main Contents Connections to mains supply Safety Instructions appropriately. cause your warranty to be invalid. factors (pesticides, fire, etc.). Safety Instructions turn off the water inlet and leave the door slightly open. This is so that the inside of your Before using the appliance Programme dial Before using the appliance as they will need to be re-used if the machine has to be transported. Check location where the washer will be installed. Make sure you have everything Never put cardboard, wood or other materials under your machine to try and stabilise To prevent leakages on the connection joints, 1 seal is included in the hose packing, (Fit Installation 9 Page Separate heavily soiled items from lightly soiled ones, even if they would normally be loading capacity indicated in the programme table for washing programmes. The Pillow case 0.2 Do not exceed the maximum fill line. Select the required washing programme by rotating the programme dial in either direction Note section 9. programme* Before starting the programme, you can select an additional function if you so wish. Page Page Washing procedure & programme selection Wipe up detergent, bleach, and other spills with a soft, damp cloth or sponge as and Do not put sharp or metal object in your washer, or they can damage the finish. Check Reconnect power supply cord. Filters are used to avoid dirt and foreign substances in the water from entering the Having the filters cleaned, you can fit them in the same way reversely. filter hole to soak up remaining water. Page Removing stains of fabric it is, and whether the fabric is colourfast(Check the care label). Trouble shooting recommended and settle the laundry in the machine discharge water. Your machine is overloaded with Water tap is turned off. Turn your faucet on. Trouble shooting Specification Connection to the mains supply If this plug is unsuitable or needs to be replaced, please note the following: For UK use only Plug fitting details (where applicable): Spare parts Spare parts Contact details or call 0845 208 8750 PCB Available at www.productcareuk.com Revision 1 Opening times: Monday - Friday