ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the tool and any accessories from the box. Place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed.
nInspect the tool carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have carefully inspected the tool, identified all loose parts, and satisfactorily operated the tool.
nIf any parts are damaged or missing, please call
nAlign the holes on the brace and the legs. Insert two carriage bolts and hand tighten using hex nuts. These are the front and back sets.
nFor the side sets, install a side brace on two legs. Add hardware and finger tighten. Repeat for the other side brace. See Figure 7.
HEX NUT
TOP BRACE
CARRIAGE
BOLT
WARNING:
If any parts are missing do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury.
Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose parts, and hardware from the packing materials, check all items with the loose parts list and drawing. If you are unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until you have obtained the missing part(s).
ASSEMBLING LEG STAND
See Figures 6 and 7.
nLocate the following hardware:
16 carriage bolts
4 carriage bolts, small
16 hex nuts
4 hex nuts, small
4 feet
nTake 4 legs and 8 braces from loose parts.
nPlace top braces inside legs.
Page 13
TOP BRACE
Fig. 6
CARRIAGE
BOLT
HEX NUT
LEG BRACE
(LONG)
Fig. 7
