Saab 9-3 M03 26Fit the heater mounting bracket to the bulkhead, Tightening torque 24 Nm 18 lbf ft

12 788 928 9

26

26

26

23

22

22Unplug the connector from the air mass sensor, separate the intake hose and remove the air fil- ter cover. Remove the hose from the air filter cover (if such a hose is fitted).

23Remove from the turbo intake pipe the small hose to the control valve (APC valve) and the hose to the carbon filter vent-valve. Remove the intake pipe.

24Remove the heat shield from the turbo compres- sor (two screws and a catch).

25Remove the coolant hoses from the connections to the heat exchanger and remove from the ther- mostat housing the hose which is nearest to the expansion tank.

Important

Retain the hose clip, it is required for re-assembly.

22 23 23 24 25

22

F920A016

26Fit the heater mounting bracket to the bulkhead.

Tightening torque 24 Nm (18 lbf ft)

Using benzine, clean an area between the sus- pension strut mounting bolts on the top of the right-hand suspension turret nearest to the engine. Remove the extra label from the heater and affix it to the cleaned area.

Important

Under no circumstances may this label conceal any part of another label or plate.

Saab 9-3 M03-