Sabrent USBDSC5 manual Hard Drive Setup, Click on “Disk Management”

Models: USBDSC5

1 20

Page 15

If the Hard‐Drive is brand new you may need to initialize it first in order to cause the Drive Letter to appear:

1. Click the Start button, right‐click on “My Computer”, and select “Manage”:

3.Locate the drive in the right column and right‐click on the drive and click “New Simple Volume”:

Image 15

Contents

Sabrent USB‐DSC5 USB 2.0 to SATA/IDE Hard Drive Adapter 2.5” Notebook IDE Hard DriveFigure A Figure B Figure C Figure D Figure A 2. Connect the USB cable from the USB‐DSC5 to an available USB port on your computerFigure A Figure B Figure C Figure D Figure E Figure F Figure A Figure G 3.5” Desktop IDE Hard DriveFigure A Figure B Figure C 2. Connect the IDE power adapter directly in the IDE driveFigure D Figure A Figure BFigure C 4. Connect the USB cable from the DSC5 to a USB port on your computerFigure A Figure A Figure B 2.5/3.5 Inch SATA DriveFigure C Figure D Figure E Figure A Figure B Figure C driveFigure D Figure E Figure F Figure A Hard Drive Setup For Windows 2000/XP/VISTA/7, no drivers or software are necessarry2. Click on “Disk Management” 5. Click “Next” 4. At the following prompt, click “Next”Click “Next” 6. Assign a drive letter to the drive, then click “Next”9. Open “My Computer” and verify that the drive shows up properly Frequently Asked Questions 4. Why doesn’t my 3 TB hard drive show up as full capacity?If the drive has already been formatted, you can skip these steps