Manuals / Sabrent / Computer Equipment / Computer Drive

Sabrent USBDSC5 manual drive, Figure A Figure B Figure C

Models: USBDSC5

1 20

Download 20 pages 58.86 Kb

Page 12

drive:

2.Connect the SATA data cable into the Sabrent Converter, and then connect the other end directly into the SATA

drive:

Figure A:

Figure B:

Figure C:

Image 12

Sabrent USBDSC5 manual drive, Figure A Figure B Figure C

Contents

Sabrent USB‐DSC5 USB 2.0 to SATA/IDE Hard Drive Adapter 2.5” Notebook IDE Hard DriveFigure A Figure B Figure C Figure D Figure A 2. Connect the USB cable from the USB‐DSC5 to an available USB port on your computerFigure A Figure B Figure C Figure D Figure E Figure F Figure G 3.5” Desktop IDE Hard Drive Figure A2. Connect the IDE power adapter directly in the IDE drive Figure A Figure B Figure CFigure A Figure B Figure DFigure C 4. Connect the USB cable from the DSC5 to a USB port on your computerFigure A 2.5/3.5 Inch SATA Drive Figure A Figure BFigure C Figure D Figure E drive Figure A Figure B Figure CFigure D Figure E Figure F Figure A Hard Drive Setup For Windows 2000/XP/VISTA/7, no drivers or software are necessarry2. Click on “Disk Management” 4. At the following prompt, click “Next” 5. Click “Next”6. Assign a drive letter to the drive, then click “Next” Click “Next”9. Open “My Computer” and verify that the drive shows up properly Frequently Asked Questions 4. Why doesn’t my 3 TB hard drive show up as full capacity?If the drive has already been formatted, you can skip these steps