Manuals
/
Sabrent
/
Computer Equipment
/
Computer Drive
Sabrent
USBDSC5 manual Connect the IDE power adapter directly in the IDE drive
Models:
USBDSC5
1
7
20
20
Download
20 pages
58.86 Kb
4
5
6
7
8
9
10
11
<
>
FAQ
Hard Drive Setup
Connect the IDE power adapter directly in the IDE drive
Page 7
Image 7
2.
Connect
the IDE
power adapter
directly in the IDE drive:
Figure A:
Figure B:
Figure C:
Page 6
Page 8
Page 7
Image 7
Page 6
Page 8
Contents
2.5” Notebook IDE Hard Drive
Sabrent USB‐DSC5 USB 2.0 to SATA/IDE Hard Drive Adapter
Figure A Figure B Figure C
Figure D
2. Connect the USB cable from the USB‐DSC5 to an available USB port on your computer
Figure A
Figure A
Figure B Figure C Figure D
Figure E Figure F
Figure A
Figure G 3.5” Desktop IDE Hard Drive
Figure A Figure B Figure C
2. Connect the IDE power adapter directly in the IDE drive
Figure D
Figure A Figure B
4. Connect the USB cable from the DSC5 to a USB port on your computer
Figure C
Figure A
Figure A Figure B
2.5/3.5 Inch SATA Drive
Figure C Figure D Figure E
Figure A Figure B Figure C
drive
Figure D Figure E Figure F
Figure A
For Windows 2000/XP/VISTA/7, no drivers or software are necessarry
Hard Drive Setup
2. Click on “Disk Management”
5. Click “Next”
4. At the following prompt, click “Next”
Click “Next”
6. Assign a drive letter to the drive, then click “Next”
9. Open “My Computer” and verify that the drive shows up properly
4. Why doesn’t my 3 TB hard drive show up as full capacity?
Frequently Asked Questions
If the drive has already been formatted, you can skip these steps
