Manuals
/
Sabrent
/
Computer Equipment
/
Computer Drive
Sabrent
USBDSC5 manual Figure C Figure D Figure E
Models:
USBDSC5
1
11
20
20
Download
20 pages
58.86 Kb
8
9
10
11
12
13
14
15
<
>
FAQ
Hard Drive Setup
Connect the IDE power adapter directly in the IDE drive
Page 11
Image 11
Figure C:
Figure D:
Figure E:
Page 10
Page 12
Page 11
Image 11
Page 10
Page 12
Contents
Figure A Figure B Figure C
Sabrent USB‐DSC5 USB 2.0 to SATA/IDE Hard Drive Adapter
2.5” Notebook IDE Hard Drive
Figure D
Figure A
Figure A
2. Connect the USB cable from the USB‐DSC5 to an available USB port on your computer
Figure B Figure C Figure D
Figure E Figure F
Figure A
Figure G 3.5” Desktop IDE Hard Drive
Figure A Figure B Figure C
2. Connect the IDE power adapter directly in the IDE drive
Figure D
Figure A Figure B
Figure A
Figure C
4. Connect the USB cable from the DSC5 to a USB port on your computer
Figure A Figure B
2.5/3.5 Inch SATA Drive
Figure C Figure D Figure E
Figure A Figure B Figure C
drive
Figure D Figure E Figure F
Figure A
2. Click on “Disk Management”
Hard Drive Setup
For Windows 2000/XP/VISTA/7, no drivers or software are necessarry
5. Click “Next”
4. At the following prompt, click “Next”
Click “Next”
6. Assign a drive letter to the drive, then click “Next”
9. Open “My Computer” and verify that the drive shows up properly
If the drive has already been formatted, you can skip these steps
Frequently Asked Questions
4. Why doesn’t my 3 TB hard drive show up as full capacity?
