Quick Start | Samson Graphite 25 specification

Quick Start

1.Connect the Graphite 25 to your computer using the supplied USB cable. The unit will receive power and transmit MIDI data via the USB connection.

2.Connect a ¼”TS pedal to the SUSTAIN pedal input.

Computer

Sustain Pedal

MIDI Device

3.Push the POWER switch to the on position.

4.Launch your DAW or virtual instrument software, and set the Graphite 25 as the MIDI Input and MIDI Output device.

5.To use the Graphite 25 with an external MIDI device (such as a sound module), connect a

5-pin MIDI cable to the MIDI OUT on the rear of the Graphite 25, and to the MIDI IN of the external device. For more information on connecting to an external MIDI device, please see “MIDI OUT” on page 26.

12

Image 12

Samson Graphite 25 owner manual Quick Start

Contents

USB Midi Controller Copyright 2013 Samson Technologies Important Safety Information Page Important Safety Information Contents Introduction Graphite 25 Features System ComponentsMinimum System Requirements Front Panel Controls and Functions Front Panel Controls and Functions Rear Panel Controls and Functions Quick Start Display Features PresetStatus Indicators Button Indicators Graphite 25 Modes Remote Control Presets Computer Preset Mode Graphite PresetRemote Control Presets User Presets Setup Mode ControllersParameter Controller Data Remark Editing the Aftertouch Control Selecting the Keyboard Velocity CurveAvailable Velocity Curves Hard Switch the Local Control Pedal SetupPreset Reset Selecting Velocity Curve for the Trigger Pads Zones Mode Editing Zones Section of the keyboard Zn Port Transmitting port Zn Ch Performance Mode Performance Mode Parameters Trigger Pads Performance Controls Transport Buttons Midi OUT Operational Flow Chart Midi Continuous Controller CC List Description Type Nrpn LSB Play MMC Factory Default Settings Controller Type Message Mode Other Factory Settings Zones Midi Note Numbers Octave Specifications Controls