35
36
37
38
39
40
41
Controls and Functions
MASTER OUTPUT SECTION
SOLO LEVEL
You can adjust the overall volume of the SOLO bus by using the SOLO LEVEL control knob. The SOLO LEVEL is active when any SOLO button is engaged.
3/4 to MIX Switch |
| 40 | |
When the 3/4 to MIX switch is engaged the green LED will illuminate let- | 36 |
| |
ting you know that the mix from the secondary, 3/4 stereo bus will be |
| ||
summed, or mixed together, with the main LEFT and RIGHT mix. So with | 38 | 35 | |
the 3/4 to MIX engaged, you will hear any channels assigned to the 3/4 |
| ||
bus, along with the channels assigned to the LEFT and RIGHT stereo |
|
| |
mix. This will allow you to use the 3/4 bus as a |
|
| |
create a |
|
| |
by pressing the 3/4 switches on those channels. Now with the 3/4 to MIX |
|
| |
switch pressed in, you can use the 3/4 OUTPUT faders to |
| 37 | |
C/ROOM + PHONES |
| ||
39 | 41 | ||
The C/ROOM + PHONES control is used to set the level sent to the con- | |||
|
|
trol room outputs, and also to the headphone jack.
MIX/2T
The MIX/2T switch selects the signal source that you are monitoring in the CONTROL ROOM and HEADPHONE outputs. When the switch is in the up position, the signal source is from the LEFT/ RIGHT MIX bus. When the MIX/2T switch is in the down position, the signal source is from the 2 TRACK input.
3/4 FADERS
The 3/4 Bus faders are the
MIX MUTE
When the switch pressed, the red LED will light indicating the Main Left and Right outputs are fully attenuated.
L MIX R FADERS
The L&R MIX faders are the
42
43
LED INDICATORS
POWER LED
The Power LED lights up to indicate that the main POWER switch, (located on the rear panel), is on and the mixer is
+48V - Phantom Power LED
The +48V LED illuminates indicating that the 48 volt phantom power is applied to the microphone
44
45
46
SOLO LED
The SOLO LED lights up to indicate that the SOLO bus is now being heard in the Headphones and Control Room outputs.
PFL LED
The PFL LED lights up to indicate that the SOLO is in PFL mode.
Output Level Meter
The OUTPUT LEVEL METER allows you to monitor the level of the signal which is being sent to the L&R MIX OUTPUT jacks.
NOTE: To avoid distortion, adjust the L/R MIX faders LEVEL control so that the 0 indicator LED lights occasionally.
43 42
44 45
46
13