Controls and Functions
MONO INPUT CHANNEL SECTION
The following section details each part of the MDR10’s MONO INPUT CHANNELS including the GAIN control, CLIP LED, 3- BAND EQ, AUX sends, PAN and LEVEL controls. The input channels one through six on the MDR10 feature high quality, discrete transistor
1
2
GAIN |
|
The MDR10’s | 1 |
60dB on the MIC input and | 2 |
| |
CLIP LED |
|
The MDR10’s MIC/LINE
The MDR10 input channels feature a
12KHz +/- 15dB shelving type The channel’s frequency response is flat when the knob is in the "12:00" position. Rotating the knob towards the right will boost the corresponding frequency band by 15dB, and rotating it towards the left will cut the frequency by 15dB.
4 MID (CUT & BOOST)3
4
5
6
7
The MID CUT & BOOST knob is used in conjunction with the MID FREQUENCY knob to create the tonal shape in the
6
7
The MID FREQUENCY is a control enabling you enhanced capabilities in the tonal shaping of the input channel signal. Thanks to the MID FREQUENCY control, you have a variable
80Hz +/- 15dB shelving type The channel’s frequency response is flat when the knob is in the "12:00" posi- tion. Rotating the knob towards the right will boost the corresponding frequency band by 15dB, and rotating it towards the left will cut the frequency by 15dB.
LOW CUT FILTEREach of the MDR10’s channels include a LOW CUT (or high pass) filter which rolls off the low frequencies from 80Hz and below at the rate of 12dB per octave.
7