Samson MDR10 UP-SETSOUND LIVE MDR10

This system shows the MDR10 connected to a pair of powered speakers like the SAMSON dB500a. The AUX 1 is connected to an external power amp, which is driving 2 monitor speakers. For inputs, two microphones are connected to channels 1 and 2’s low-impedance inputs, and the output of the Bass Direct Box is also connected to the low-impedance input on channel 4. The Keyboards, as well as the Lead and Rhythm Guitar signal processor's outputs, are connected to the MDR10’s line inputs.

UP-SET SOUND LIVE MDR10

MDR10’s AUX OUT connected to an external monitor amp.

Ups-Set System MDR10

Contents

Page Page Introduction MDR10 Features Front Panel Layout Rear Panel Layout Controls and Functions Page Page Page Page REAR PANEL MONO INPUT CHANNEL SECTION AUX 1 PRE/POST switch 10AUX 2 / DSP Send STEREO - DUAL/MONO INPUT CHANNEL SECTION (STEREO/DUAL-MONOINPUT CHANNEL CONTINUED) 15 HF (HIGH FREQUENCY) AUX 1/2 Switch AUX Control Knob SOLO Switch 2 TRACK INPUT AND OUTPUT 24 BIT DIGITAL EFFECT SECTION Auxiliary Returns AUXILARY SECTION - continued MASTER OUTPUT SECTION LED INDICATORS CHANNEL 1–8MIC and LINE INPUTS Stereo/ Dual Mono Input Channels EXTERNAL OUTPUT JACKS 5 LEFT/RIGHT MIX 6 3/4 OUTPUT 7 FX RET 1 LEFT/RIGHT 8 FX RET 2 LEFT/RIGHT BASIC OPERATION CONNECTING MICROPHONES AND INSTRUMENTS NOTE : SETTING THE INPUT GAIN USING THE DIGITAL EFFECTS SENDING AN INDEPENDENT MIX TO THE MONITOR SPEAKERS USING AN EXTERNAL EFFECT PLAYING BACK A CD USING 2TK LEVEL RECORDING A MIX FROM THE MDR10 UP-SETSOUND LIVE MDR10 Page CONNECTING THE MDR10 CLIP Indicators Meters Internal DSP Effects Phantom Power Power Requirement