Front Panel Layout

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

42

43

44

45

46

56

55

54

53

52

51

50

49

48

47

1CLIP – Red LED will illuminate, indicating when the GAIN control has been adjusted too high.

2GAIN – Used to set the input level of the mic pre and line input.

3HIGH FREQUENCY - Controls the high band level of the Channel Equalizer, +/- 15 dB.

4MID CUT & BOOST - Controls the level of mid-range ,+/- 15 dB at the frequency set by the Mid Frequency control.

5MID FREQUENCY - Used to set the center point of the mid band of the Channel Equalizer from100 Hz to 5KHz.

6LOW FREQUENCY - Controls the low band of the Channel Equalizer, +/- 15 dB at 80Hz.

7LOW CUT – Bass roll off switch at 80Hz used to eliminate unwanted low end rumble and hum.

8AUX 1 – Pre fader auxiliary send that can be used with an external effects processor, or to create a cue or monitor mix.

9AUX 1 PRE/POST Switch This LED back-lit switch is used to select the point in the audio path that the channel’s sig- nal is sent to the AUX 1 bus, either before or after the input fader.

10AUX 2/DSP – Post fader auxiliary send connected to the internal 24 BIT DSP effect processor and can also be used with an external effects processor.

4