Samsung 3759 technical manual Receiver & display unit Standard type

II. Control System

4. Installation

4-6. Receiver & display unit - Standard type

(1) Accessories

Function	Cable-Tie(2)	Cable Clamp	M4x16	Owner’s	Installation
controller (1)		(6)	Tapped Screw	instructions(1)	manual (1)
			(7)

Wire kit

(Length:10m)

(2)Installation

1)Remove the receiver & display unit cover by using the tab on its bottom.

2)Open the receiver & display unit.

3)Connect the end of the connector wire to the receiver & display unit and connect the other end of the wire to the MAIN PCB (CN91) as shown in figure.

◆ Do NOT keep the receiver & display unit cable with a 220V cable because the remote controller cables have low voltage.

Receiver &

display unit

4)Close the receiver & display unit.

5)Secure the receiver & display unit on the wall with two screws.

6)Reassemble the receiver & display unit cover.

◆ The receiver & display unit must be installed by an installation specialist.

◆Before installing the receiver & display unit, ensure that you have turned off the main power.

◆All receiver & display unit cable should be installed according to the national wiring rules and you must install it in the wall not to be touched by users.

I22