DRAINING WATER WITHOUT USING THE WATER TANK

You can use the dryer without using the water tank by following the procedures below.

CONNECTING THE DRAIN HOSE

The Dryer can pump the condensed water outside of the DRYER directly with drain hose provided.

The procedures to connect the drain hose are as follows.

1. Disconnect the drain hose A .

A

2. Connect the drain hose A to the other part.

A

DRYER YOUR INSTALLING

3. Connect accessory hose (long drain hose)

B to the hole

B

next to the part that is connected to drain hose A .

•Because the dryer’s drain pump can only pump up

CAUTION the drain water to 90 cm height, when you connect

the drain hose B to the drain point, make sure that the height of drain point does not exceed 90 cm.

A drainage error may occur if the drain point exceeds

90 cm. If a drainage error occurs, the control panel displays an error code.

•After connecting the drain hose, you can directly drain the condensed water via the drain-outlet through the connected drain hose or through the washstand or the drain- outlet of the washstand.

English - 15

DV4000H_DC68-03408P-08_EN.indd Sec3:15

2017-07-20 ￿￿ 5:35:25