Precautions
1.Setting up
-Refer to the identification label located on the rear of your player for its proper operating voltage.
-Install your player in a cabinet with adequate ventilation holes. (7~10cm) Do not block ventilation holes on any of the components for air circulation.
-Do not push the disc tray in by hand.
-Do not stack components.
-Be sure to turn all components off before moving the player.
-Before connecting other components to this player, be sure to turn them off.
-Be sure to remove the disc and turn off the player after use, especially if you don’t use it for a long time.
2.For your safety
-This product utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
-Do not open covers and do not repair yourself. Refer servicing to qualified personal.
3.Caution
-Your player is not intended for industrial use but for domestic purposes. Use of this product is for personal use only.
-Do not put any container filled with liquid or any small metal objects on the player.
-Exterior influences such as lightning and static electricity can affect normal operation of this player. If this occurs, turn the player off and on again with the POWER button, or disconnect and then reconnect the AC power cord to the AC power outlet. The player will operate normally.
-When condensation forms inside the player due to sharp changes in temperature, the player may not operate correctly. If this occurs, leave the player at room temperature until the inside of the player becomes dry and operational.
4.Disc
-Do not clean
-Do not touch the disc’s signal surface. Hold by the edges or by one edge and the hole in the center.
-Wipe the dirt away gently; never wipe a cloth back and forth over the disc.