Samsung DVD-VR325 instruction manual Troubleshooting DVD

Troubleshooting (DVD)

Reference

Problem	Explanation/Solution
icon appears on	You cannot use the operation or function due to one of the following reasons:
	(1) Your DVD disc does not support the feature (for example, angles)
the screen.
	(2) You've requested a title, chapter, or scan time that is out of the correct range.
Play mode settings are	The disc does not support all the selected functions.
different from the set-	In this case, some settings you configure on the Setting menu may not work properly.
tings configured with
the Setting menu.
Cannot change the	Aspect ratio is fixed for DVD disc.
aspect ratio.
No audio output.	Check whether you selected correct digital output options in the Audio Output Options menu.
No video or audio output.	Did you move your DVD Recorder & VCR suddenly from a cold place to a warm place?
The disc tray is ejected	In this case, remove discs and wait for one to two hours with the power on, and then, insert
after 2 to 5 seconds.	the disc and try to playback again. It will work properly when condensation has evaporated.
Angle operation does not	Angle operation is available only when the disc contains images captured at different angles.
work during playback of a
DVD disc.
The disc revolves, but	• Check whether there is damage or foreign materials on your disc.
no image or bad quali-	• Some discs with bad manufacturing quality may not be played back.
ty images are output.	• If the scene changes from dark to bright suddenly, the screen may jitter temporarily, but it
	is not a defect.
Desired sound language	Sound languages and subtitle languages are disc-specific.
and subtitle language	Only the sound and subtitle languages contained on a DVD disc are available and
are not played.	displayed on the disc menu.
No progressive	• Check whether PSO is displayed on front panel.
output.	• Make sure to change the component video output using the Progressive button when the
	disc is stopped.
The remote control	• Point the remote control at the remote control sensor on your DVD Recorder & VCR.
doesn't work.	Operate within distance. (15ft)
	Remove obstacles between your DVD Recorder & VCR and remote control.
	• Check whether the batteries are depleted.
Other problems	• Read the table of contents and then find and read the sections describing your problem,
	and follow the directions given.
	• Turn the unit off and on.
	• If your problem still persists, contact your nearest Samsung service center.
No HDMI output.	• Check the Video output is HDMI enabled.
	• Check the connection between the TV and the HDMI jack of the DVD Recorder & VCR.
	• See if your TV supports this 480p/720p/1080i DVD Recorder & VCR.
Abnormal HDMI	• If snow noise appears on the screen, it means that TV does not support HDCP (High-bandwidth Digital
output screen.	Content Protection).
HDMI output Jitter	• Check your TV system setup correctly.
	• Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz.
	for 720P/1080i HDMI (High Definition Multimedia Interface) Output.
	• Please refer to the user’s manual of your TV.

86 - English