Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1.Plug the incoming cable into the ANT 1 IN (CABLE) terminal on the back of the TV.
➢ Because this TV is
ANT 1 IN (CABLE)
Connecting to a Cable Box that Descrambles All Channels
ANT IN | ANT OUT |
1.Find the cable that is connected to the ANT OUT terminal on your cable box.
➢ This terminal might be labeled “ANT OUT”, “VHF OUT” or simply, “OUT”.
2. Connect the other end of this cable to the ANT 1 IN (CABLE) terminal on the back of the TV.
ANT 1 IN (CABLE)
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a
ANT IN
Incoming
cable
Splitter
1.Find and disconnect the cable that is connected to the ANT IN terminal on your cable box.
➢This terminal might be labeled “ANT IN”, “VHF IN” or simply, “IN”.
2.Connect this cable to a two-way splitter.
Incoming
cableSplitter
Cable Box
3.Connect an Antenna cable between an OUTPUT terminal on the splitter and the IN terminal on the cable box.
Incoming
cable
Splitter
Cable Box
RF (A/B)
Switch
4.Connect an Antenna cable between the ANT OUT terminal on the cable box and the
Incoming
cable
Splitter
| RF (A/B) |
Cable Box | Switch |
5.Connect another cable between the other OUT terminal on the splitter and the
TV Rear |
Incoming |
| ANT 1 IN (CABLE) |
cable |
| |
Splitter |
| |
| RF (A/B) | |
|
|
Cable Box | Switch |
6.Connect the last Antenna cable between the OUT terminal on the RF (A/B) switch and the ANT 1 IN (CABLE) terminal on the rear of the TV.
After you have made this connection, set the A/B switch to the “A” position for normal viewing. Set the A/B switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B”, you will need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)
