4 Remove six large screws from the rear side of the display.

Insert the bolts, dish-type washers, and insulation holder into the six screw-

5 holes as shown in the following figure:

Œ Bolt

´ Insulation holder

Put the insulation rubber point protruding from the rear top of the display in

6 the groove on the top of the wall attachment panel. Lift up the display a little bit so that the insulation rubber point at the bottom of the rear side of the display is put to the groove at the bottom of the wall attachment panel.

(Do not lift the display with any pressure. The insulation rubber at the top may be taken off. )

Œ

´

16

Separating the Display from the Wall Attachment Panel

Remove the fixing bolts from both sides (left and right) of the wall attachment panel. Lift and pull the bottom of the display a small amount, to separate the insulation holder point from the bottom of the wall attachment panel.

Lift the display and separate the insulation holder point from the groove on top of the wall attachment panel.

Œ

´

17

Page 9
Image 9
Samsung HPL5025 manual Separating the Display from the Wall Attachment Panel