Connecting the AM (MW)/LW Aerial
B
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are marked AM .
To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
DIGITAL OUT
OPTICAL
Connecting the FM Aerial
How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket (75Ω) marked FM on the rear of the system.
Follow the instructions given on Page 23 to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75Ω coaxial cable (not supplied).
Viewing the Various Functions on Your System
You can view the various functions available on your system.
1 Press the Demo button.
Result: The various functions available are listed in turn on the display.
All these functions are described in detail in this booklet. For instructions on how to use them, refer to the appropriate sections.
2 To cancel this function, press Demo again.
NTSC/PAL Selection Method
According to a DISC or TV, Press the REC/Pause button on the front panel.
Set the system to standby(power off) mode, press the REC/Pause button on the front panel.
Result: Each time the REC/Pause button is pressed, the following appears in the display:
NTSC 
PAL 
Setting the Clock
* This function can be operated only from the main unit. | GB |
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing On/Standby. | |
2 | Press Timer/Clock twice. |
|
| Result: CLOCK is displayed. |
|
3 | Press Enter. |
|
| Result: The hour flashes. |
|
4 |
|
|
To... | Turn the Multi Jog knob to the... | |
| Increase the hours | Right |
| Decrease the hours | Left |
5 | When the correct hour is displayed, press Enter. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Turn the Multi Jog knob to the... | |
| Increase the minutes | Right |
| Decrease the minutes | Left |
7 | When the correct time is displayed, press Enter. | |
| Result: The clock starts and is displayed, even when the system is | |
in standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
You can also use 
/ 
buttons to instead Multi Jog knob in step 4,6.
1 | 4,6 | 4,6 |
| 3,5,7 | |
|
| |
|
| 4,6 |
| 2 |
|
12 | 13 |
