CHECKING THAT YOUR OVEN IS OPERATING CORRECTLY
The following simple procedure enables you to check that your oven is working correctly at all times. If you are in doubt, refer to the section entitled “Troubleshooting” on the page 20.
The oven must be plugged into an appropriate wall socket. The turntable must be in position in the oven. If a power level other than the maximum (100 % - 950 W) is used, the water takes longer to boil.
Open the oven door by pulling the handle on the right side of the door. Place a glass of water on the turntable. Close the door.
1. Set the power level to maximum by turning COOKING
POWER CONTROL knob.
2.Set the time 4 to 5 minutes by turning the TIME/WEIGHT dial.
Result: The oven light comes on and the turntable starts rotating.
1) Cooking starts and when it has finished the oven beeps 4 times.
2)The end reminder signal will beep 3 times (once every minute).
3)The current time is displayed again.
The oven must be plugged into an appropriate wall socket. The turntable must be in position in the oven.
If a power level other than the maximum is used, the water takes longer to boil.
SETTING THE TIME
Your microwave oven has an inbuilt clock. When power is supplied, “88:88” and then “12:00” is automatically displayed on the display.
Please set the current time. The time can be displayed in either the
•When you first install your microwave oven
•After a power failure
Do not forget to reset the clock when you switch to and from summer and winter time.
Auto energy saving function
If you do not select any function when appliance is in the middle of setting or operating with temporary stop condition, function is canceled and clock will be displayed after 25 minutes.
Oven Lamp will be turned off after 5 minutes with door open condition.
1. To display the time in the..
Press the Clock button once or twice.
2. Turn the TIME/WEIGHT dial to set hour.
3. Press the Clock button.
4. Turn the TIME/WEIGHT dial to set minute.
5. Press the Clock button.
English - 14
|
| ||
|
| ||
|
|
|
|