• If the Refrigerator is not level back and front, put a solid panel (such as a plastic panel, a plastic ruler, etc.) on the fl oor where the rear legs will rest, and then fi x it in place with plastic tape.

When you push in the Refrigerator, make sure the rear legs rest on the panel.

If you have a wooden fl oor or similar soft fl oor, take care not to damage the fl oor when pushing the Refrigerator into place.

HOW TO ADJUST THE DOOR HEIGHT

If any one of the doors is lower than the other:

• Check if the Refrigerator is level before adjusting the door.

Adjust the door height difference by inserting a Snap Ring ( 1 ) as shown between the door and the hinge.

You can use the rings to raise the right side door of the fresh food compartment and both doors of the freezer compartment.

1

After checking the height difference, select one Snap Ring with a suitable thickness. Important: You can only insert one snap ring. Inserting two or more Snap Rings may cause the Snap Rings to slip out or make a rubbing noise.

Lift up the lower door and insert the Snap Ring into the space between the Door and the Hinge.

• To avoid injury, insert or remove Snap CAUTION Rings carefully.

Keep the Snap Rings out of the reach of children and make sure that children do not play with them or put them into their mouths.

• 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap Rings come with the Refrigerator.

If the Refrigerator is level before you load it with food, the Refrigerator may become unbalanced due to the weight of the food.

If this occurs, adjust the level again using the same procedure.

If you raise the door too far, it can rub against the Top Cover.

Snap Rings included with the refrigerator:

1 mm

1.5 mm

2 mm

2.5 mm

 

 

 

 

English - 22

DA68-03013E-03.indb 22

2015. 8. 26. ￿￿ 10:38

Page 22
Image 22
Samsung RF34H9950S4/ES manual HOW to Adjust the Door Height, Snap Rings included with the refrigerator