HOW TO ADJUST THE DOOR GAP

If the gap between the left and right fridge compartment doors is not even.

• You can adjust the gap by turning the bolt at the top right of the cold storage compartment door.

•Do not turn the bolt too far. You can break it.

1.With the doors closed, remove the 6 screws holding the top cover using a Phillips screwdriver, and then lift it off together with the connected cables.

2. Turn the bolt with a 4 mm hexagonal L-wrench to adjust the gap.

(Not provided)

3.Turn the bolt clockwise to ( ) widen the

gap. Turn the bolt counter clockwise ( ) to narrow the gap.

INSTALLING THE WATERDISPENSER LINE

A water dispenser with a fi lter is one of the helpful features on your new refrigerator.

To help promote better health, the water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms.

You may need to purchase a water purifying system to do that.

The water line also connects to the ice maker. For the ice maker to operate properly, water pressure of 138~862 kPa (1.4~8.8 kgf/cm³) is required.

If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly fi lled.

To do this, press the water dispenser lever until the water runs from the water outlet.

• Water line installation kits are available at extra cost from your dealer.

We recommend using a water line installation kit that contains copper tubing and ¼” compression nut.

•New hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.

UP SETTING

English - 23

DA68-03013E-03.indb 23

2015. 8. 26. ￿￿ 10:38