•Do not locate the refrigerator where it may become wet.
When moving your refrigerator
To prevent floor damage, be sure the front
CAUTION adjusting legs are in the up position (above the floor).
Refer to ‘Adjusting the doors’ in the manual (on page 9).
Required Tools (Not provided)
You need the following tools to complete the installation of your refirgerator:
Philips screw- | Socket wrench | |
driver (+) | driver | (10mm) |
|
|
Control Lever | |
screw |
|
FLOORING
For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor. This surface should be strong enough to support a fully loaded refrigerator, or approximately 359lbs (165kg). To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working.
When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side.
ACCESSORIES AND REQUIRED TOOLS
The following accessories are included with your refigerator:
Hex wrench | Fastener |
Pliers | Allen wrench (3/16”) (5mm) |
REMOVING THE REFRIGERATOR DOORS
For some installations you need to remove the fridge and flex doors and the freezer drawer so you can move the refrigerator to its final location. Do not remove the doors/drawer if you don't need to. If you do not need to remove the doors/drawer, go to Adjusting the Level on page 8. If you need to remove the doors/drawer, continue below.
Before removing the door/drawer, make sure you read the following items:
Disconnect power to the refrigerator before WARNING removing the door or drawer.
•Be careful not to drop, damage or scratch the door/drawer while removing them.
•Be careful not to get injured while removing the door/drawer.
•Reattach the door/drawer properly to avoid:
-Moisture from air leakage.
-Uneven door alignment.
-Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors WARNING while removing the doors.
Disassemble the refrigerator doors
1.With the door opened, remove the cap top table ( 1 ) with a
06_ setting up
13. 4. 25. �� 2:18 |
