Samsung RF4267HABP, RF4267HARS, RF4267HAWP user manual Adjusting The Freezer Drawer Level

	Adjustment
Fixed part	part

ADJUSTING THE FREEZER DRAWER LEVEL

Adjustment part

up

The left door is fixed. To make minor adjustments between doors, adjust only the right door.

1.Pull out the Convertible door ( 1 ) to expose the lower hinge ( 2 ).

2.Insert the supplied allen wrench (3/16”) ( 3 ) into the shaft ( 4 ) of the lower hinge.

3.Please adjust the height by turning the hex wrench ( 3 ) clockwise ( DOWN ) or counter-

clockwise ( UP ).

When you turn the hex wrench counter-

clockwise (), the door will move up.

2
3	3
4

1

1.After adjusting the doors, insert the supplied fastener ( 6 ) using a pliers ( 5 ) in the gap between the hinge-grommet ( 7 ) and the lower hinge ( 8 ). The number of fasteners you’ll need to insert depends on the gap.

2 fastener are enclosed with the refrigerator. The thickness of each fastener is 0.04”.

Freezer Drawer

1.Locate the height-adjuster ( 1 ) in the freezer drawer.

Unscrew the 8 Phillips screws ( 2 ) slightly to loosen the door.

1

2

2. Loosen the controller
screw ( 3 ) with a Phillips	3
screwdriver (+).

3.Find the best level to align the door

slope.

• After adjustment, tighten the controller screw ( 3 ) and then philips screws.

Example) The slope is about 0.08inch (2mm) as shown below. - Rotate the height adjuster to -2.0 to reduce the door slope.

Slope

Reference plane

01setting

setting up _09

DA68-02481A-10.indb 9 13. 4. 25. �� 2:18