setting uP tHe ReFRigeRAtoR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.
2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessories listed below.
PU G ESTTIN 01
Water filter | Hex wrench | Fastener | Compression fitting Compression nut | Cap Top Table |
Required Tools(Not provided)
Philips screwdriver(+) | Socket wrench (7/16”) | Pliers | Allen wrench(3/16”) |
Removing the refrigerator doors
Some installations require door removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read following items.
Disconnect power to the Refrigerator before removing doors or drawers.
WARNING
•Be careful not to drop the door and door scratch and damage while removing the door/drawer.
•Be careful not to get injured while removing the door/drawer.
•After reattaching the door/drawer.
It is possible to have sweat by air leakage.
It is possible to have uneven door alignment. It is possible to have more energy bills.
Disassemble the Refrigerator doors
Be careful not to drop and scratch the doors while WARNING removing the doors.
Disassemble the Refrigerator doors
1.After door opened, remove the hinge cover cap ( 1 ) with a
2
1
Setting Up _9