CAUTION
CAUTION
• In case ice doesn’t come out, pull out the ice bucket and press test button located on the right side of ice maker.
•Do not press the test button continuously when the tray is filled with ice or water as shown on the figure.
Water may overflow or ice jamming may occur.
•Normal Use
To fill ice bucket to maximum capacity after installation, make sure to | Check the water level | ||
do the following steps. | |||
OPERA02 | |||
1. | Allow your refrigerator to operate and cool down for 24 hours | ||
| (or 1 full day). |
| |
2. | Waiting 24 hours will allow your ice maker to cool properly. | Test button | |
3. | Dispense 4 to 6 ice cubes into the glass. | G | |
4. | After 8 and 16 hours, dispense a full glass of ice at each time. | TIN | |
When you dump the ice from the ice bucket, you should press the | |||
| |||
dispenser lever once with ice cubed or crushed function on to get new ice faster after replacing the ice bucket in the refrigerator.
Whenever all ice is used at one time, the above step 3 and4 must be repeated (before dispense the first 4 to 6 ice cubes, it needs waiting 8 hours). This will replenish the ice cubes and ensure maximum ice production.
Using the water dispenser
Place a glass underneath the water outlet and push gently against the water dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the water from splashing out.
If you have just installed the Refrigerator or just installed a new water filter, pour out the first six glassfuls of water to flush out impurities in the water supply system. Make sure water flows cleanly before drinking.
Using the ice off Function
When selecting the Ice Off mode, remove all ice cubes from the bucket. If you are not using the ice dispenser, the ice cubes may clump together. Pull the lock lever forward to throw away ice cubes or remove clumped ice from the bucket. Push the bucket back until you hear a click.
Use only the ice maker provided with the refrigerator.
CAUTION The water supply to this refrigerator must only be installed/connected by a suitably qualified person and
connect to a potable water supply only.
In order to operate the ice maker properly, water pressure of 138 ~ 862Kpa is required.
If you have a long vacation or business trip and won’t use water or ice dispensers, close the water valve.
Wipe excess moisture from the inside and leave the doors open.
Do not put your fingers, hands or any other unsuitable objects in the chute or
Never put your finger or any other objects in the dispenser opening. - It may cause injury.
Do not disassemble the ice maker personally. It may cause disorder. Do not wash or spray the ice bucket with water.
Water clouding phenomenon
All water provided to refrigerators flows through the core filter which is an alkaline water filter. In this process, the pressure in the water that has flowed out of the filter gets increased, and oxygen and nitrogen become saturated. When this water flows out in the air, the pressure plummets and the oxygen and nitrogen get supersaturated so that they turn into gas bubbles. The water could look misty due to these oxygen bubbles.The water may look temporarily cloudy due to these oxygen bubbles. After a few seconds, the water will look clear.
The water tank’s capacity is approximately one third (1/3) of a gallon.
Please wait 1 second before removing the cup after dispensing water to prevent spills. Do not pull out the lever dispenser after taking out ice or water. It comes back automatically. Ice is made in cubes. When you select “Crushed”, the ice maker grinds the ice cubes into crushed ice.
