setting uP tHe ReFRigeRAtoR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.

2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.

4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.

Check the accessory list below.

PU G 01ESTTIN

Water filter

Hex wrench

Fastener

Compression fitting

Compression nut

(DA29-00003B)

(DA80-00002C)

(DA60-00143B)

(DA62-00305A)

(DA74-00070B)

Removing the refrigerator doors

If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

Tools you will need

Philips screwdriver

Flat-blade screwdriver

Wrench

Pliers

Allen wrench(3/16”)

Disassemble the Refrigerator doors

1.With the door opened, remove the Hinge Cover cap ( 1 )with a Flat head screwdriver, and close the door.

Remove the 3 screws holding down the Hinge Cover and remove the Hinge Cover ( 2 ).

2

1

Setting Up _9

Page 9
Image 9
Samsung RFG299AA user manual Setting uP tHe ReFRigeRAtoR, Removing the refrigerator doors, Tools you will need