Samsung RFG299AA user manual Setting up your French Door Refrigerator

Setting up your French Door Refrigerator

GEttinG READy to instALL tHE REFRiGERAtoR

Congratulations on your purchase of the Samsung French Door Refrigerator. We hope you enjoy the state-of-art features and efficiencies that this new appliance offers.

Selecting the best location for the Refrigerator

• A location with easy access to the water supply.

• A location without direct exposure to sunlight.

• A location with level (or nearly level) flooring.

• A location with enough space for the Refrigerator doors to open easily.

• Allow sufficient space for air circulation of the internal cooling system.

If the Refrigerator does not have enough space, the internal cooling system may not work properly.

First thing! Make sure that you can easily move your Refrigerator to its final location by measuring doorways (both width and height), thresholds, ceilings, stairways, etc.

The following chart details the exact height and depth of Samsung French Door Refrigerator.

	MODEL		RFG299AA
	Capacity(Cu.Ft)		28.5
		Width	35 ¾
	Case Height	with Hinge	70
Dimension		without Hinge	68 ⅝
(inches)
	Depth	with Door	35 ¾
		without Door	29 ⅛

•Allow clearance to the right, left, back and top when installing. This will help reduce power consumption and keep your energy bills lower.

•Do not install the Refrigerator where the temperature will go below 50ºF (10ºC).

When moving your refrigerator

CAUTION To prevent floor damage be sure the front leveling legs are in the up position(above the floor).

Refer to ‘Leveling the refrigerator’ in the manual(at page 15)

	Control Lever
Screwdriver(-)

FLOORING

For proper installation, this refrigerator must be placed on a level surface of hard material that is the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately

660lbs(299kg). To protect the finish of the flooring, cut a large section of the cardboard carton and place under the refrigerator where you are working. When moving, be sure to pull the unit straight out and push back in straight.

8_ Setting Up