SEVERE WARNING SIGNS FOR TRANSPORTATION AND SITE
•When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged.
If a leak is detected, avoid any naked flames or potential sources of ignition and air the room in which the appliance is standing for several minutes.
•In order to avoid the creation of a flammable
•Never start up an appliance showing any signs of damage.
If in doubt, consult your dealer. The room where the refrigerator will be sited must be 1 m³ in size for every 8 g of
The amount of refrigerant in your particular appliance is shown on the identification plate inside the appliance.
SEVERE WARNING SIGNS FOR INSTALLATION
•Do not install the refrigerator in a damp place or place where it may come in contact with water.
•Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliance.
•Do not plug several appliances into the same multiple power board.
The refrigerator should always be plugged into its own individual electrical which has a voltage rating that matched the rating plate.
•If the wall socket is loose, do not insert the power plug.
•Do not use a cord that shows cracks or abrasion damage along its length or at either end.
•Do not bend the power cord excessively or place heavy articles on it.
•Do not use aerosols near the refrigerator.
•This refrigerator must be properly installed and located in accordance with the manual before it is used.
•Connect the power plug in proper position with the cord hanging down.
•Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
•When moving the refrigerator, be careful not to roll over or damage the power cord.
• The appliance must be positioned so that the plug is accessible after installation.
• The refrigerator must be grounded.
•Never use gas pipes, telephone lines or other potential lightening rods as ground.
•If the power cord is damaged, have it replaced immediately by the manufacturer or its service agent.
•The fuse on the refrigerator must be changed by a qualified technician or service company.