SETTING UP THE
REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational. If not, fi rst check the power supply and electricity source or try the troubleshooting section at the back of this user’s guide. If you have any further questions, contact your Samsung Electronics service center.
1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.
2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.
SETTING UP THE REFRIGERATOR DOORS
If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.
Separating the Water Supply Line
from the Refrigerator
1.Pull the two water lines (which are in the Fixer) out to the front.
2.Remove two water lines (White one is for water and the other one is for ice) by pressing the coupler ( 1 ) and pulling the water line ( 2 ) away.
1
Make sure the color of the water lines match.
2
Reattaching the Water Supply Line
1.The Water Line must be fully inserted to the Center of transparent coupler to prevent water leakage from the dispenser.
2.Insert the 2 clips in the install pack and check that each clip holds the line firmly.
| Center of transparent coupler |
clip A (¼”) | clip A (¼”) |
(6.35mm) | (6.35mm) |
Do not cut the water line. Gently separate it from the coupler.
Removing the freezer door
A few things to mention first.
•Make sure that you lift the door straight up so the hinges are not bent or broken.
•Be careful not to pinch the water tubing and wire harness on the door.
•Place doors on a protected surface to prevent scratching or damage.
08_ setting up
