CHANGING THE WATER FILTER
To reduce risk of water damage to your WARNING property DO NOT use generic brands of
water fi lers in your SAMSUNG Refrigerator.
USE ONLY SAMSUNG BRAND WATER FILTERS.
SAMSUNG is not legally responsible for any damage, including, but not limited to property damage caused by water leakage from the use of a generic water fi lter.
SAMSUNG Refrigerators are designed to work ONLY WITH SAMSUNG Water Filters.
If you want to purchase any accessories, please contact with Samsung service center.
The “Filter Indicator” light lets you know when it is time to change your water fi lter cartridge. To give you preparation time to get a new fi lter, the red light will come on just before the capacity of the current
filter runs out. Changing the fi lter on time provides you with the freshest, cleanest water from your fridge.
To change the water fi lter, follow these steps:
1.Turn the water filter 90˚
2.Pull the water filter from
the filter housing.
3. Insert new water filter inside the filter housing.
4.Turn the new water filter 90˚ clockwise.
5.Press the “Ice Off / Hold 3 Sec for Filter Reset” button for about 3 seconds to reset the water filter. The color of indicator changes from red to light off.
A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
Removing residual matter inside the water supply line after installing a new filter
1.Press the Water button, and then push the Dispenser Lever with a cup or glass.
2.Flush 1 gallon of water through the filter, one cup or glass at a time. (Flush approximately 6 minutes.) This will clean the water supply system
and remove air from the lines.
-Additional flushing may be required in some households.
3.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
•Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.
•Allow the storage tank on the reverse osmosis system to refill after heavy usage.
•If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter.
If you have questions about your water pressure, call a licensed, qualifi ed plumber.
Ordering replacement filters
To order more water fi lter cartridges, contact your authorized Samsung dealer.
18_ operating
