Samsung RSH5PTPN1/EUR, RSH5PTTS1/EUR manual Checking the Water Dispenser Line Optional

CHECKING THE WATER DISPENSER LINE (OPTIONAL)

A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup can be fi lled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.

Water Line installation Kits are included. You can fi nd it in one of the freezer drawers.

INSTALLING THE WATER

DISPENSER LINE

For Interior model

Parts for water line Installation

2 Pipe connector

1Water line fi xer and screws

4.After connecting the water supply to the water

filter, turn your main water supply back on and dispense about 1l to clear and prime the water

filter.

Close Main

Water pipe

Close Main	NO GAP
Water pipe

Connecting the water line to the refrigerator

1.Remove the dust cap from the water line on the rear of the unit and fi t a compression nut from the install kit.

2.Remove the water pipe from the install kit and fi t a compression nut to one end.

3.Join the two pipes together using the compression joint from the install kit ensuring that the joint is water tight.

4.Join the other end of the install pipe to the main water supply and turn on the water to check for leaks.

Loosen a	Remove
	cap

3 Water line 4 Water Filter

Connecting to the water supply line

1. fi rst, shut off the main water supply line.

Water Line

from unit

Water Line

from Kit

No gap

2. locate the nearest cold, drinking water line.

3. follow the Water line Installation Instructions in the

installation kit.

CAUTION

The water line must be connected

to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifi er to malfunction.

Only connect the water line to a drinkable water source.

If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug, leak-free connection.

Before being used, the leakage in these CAUTION places should be examined

12_ setting up

DA99-02318R(0.3).indb Sec4:12 2012.10.6 12:25:29 PM