Connect the water line to the refrigerator.

-Remove the compressor cover of the refrigerator.

-Connect the water line to the valve, as shown in the fi gure.

-When connected, check if there is any leakage. If any, repeat the connection.

-Reattach the compressor cover of the refrigerator.

WATER LINE

CONNECTION NUT

INSTRUCTIONS

COMPRESSOR COVER OF

REFRIGERATOR

Check the amount of water supplied to the ice tray.

1. Lift up the icemaker cover and gently pull out.

2. When you press the Test button for 3 seconds, the ice cube container is fi lled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below).

If the water level is too low, the ice cubes will be small. This is a water pressure problem from with in the main water pipes, not the refrigerator.

1

01 SETTING UP

Secure the water line.

-Using clip ”A”, fi x the water line to the wall (the back of refrigerator).

-When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed.

CLIP A

WATER LINE

Ice maker

Feeler Arm

Removing any residual matter inside the water supply line after installing filter.

1.Turn ON the main water supply & turn OFF the valve to the water supply line.

2.Run water through the dispenser until the water runs clear (approx. 1L). This will clean the water supply system and remove air from the lines.

3.Additional fl ushing may be required in some households.

4.Open the refrigerator door and make sure there are no water leaks coming from the water fi lter.

A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.

Check the water level

Test button

2

setting up _15

DA99-02318R(0.3).indb Sec4:15

2012.10.6 12:25:34 PM

Page 15
Image 15
Samsung RSH5PTTS1/EUR manual Connect the water line to the refrigerator, Check the amount of water supplied to the ice tray