Samsung SCC-C4203AP Auto Focus, Motion Det, MIRROR Horizontally flips the video output signal

☞CTRL TYPE : You can select the A, B, C, or D mode depending on the input of the wired remote control terminal. (See page 7.)

☞RS-485 :It sets up ADDRESS, PROTOCOL, and BAUD RATE of RS-485 communication.

(BAUD RATE: 2400bps, 4800bps, 9600bps, 19200bps, 38400bps)

Caution : A communication error may occur if you connect more than one camera set with an identical address.

AUTO FOCUS

In the AUTO FOCUS option, you can specify the Focus method to AF, MF, or ONEAF.

☞AF : Focuses automatically by continuously monitoring the screen in AUTO FOCUS mode. It does not process the FOCUS button input because it focuses automatically during ZOOM.

☞PIP : This is the Picture in Picture feature. It will show a screen reduced by 1/16 of the main screen only when operating the Digital Zoom. If you set the PIP option to ON and press the ENTER button, you can use the UP, DOWN, LEFT, and RIGHT buttons to set the PIP position.

*The PIP feature does not work in a low speed shutter mode. The MIRROR feature does not work on the PIP window.

☞MF : You can manually adjust the focus.

☞ONEAF : Focuses about 5 seconds only when ZOOM is moved Wide to Tele. It is same as MF mode while in STOP mode, and same as AF mode after ZOOM Tele.

(SET UP)
		E
CAMERA ID	OFF
IRIS	ALC...
SHUTTER	OFF
AGC	LOW
WHITE BAL	ATW
SPECIAL	...
AUTO FOCUS	AF
MOTION DET	OFF
PRESET	...
COLOR/BW	COLOR
EXIT	QUIT

(SPECIAL)
EANGUAGE	ENGLISH
V-SYNC	LINE...
CTRL TYPE	A
RS-485	...
PIP	ON
MIRROR	OFF
D-ZOOM	OFF
POSI/NEGA	+
ZOOM SPEED	3
DETAIL	(0) ----I--
RET

Press the

ENTER button.

PIP

MOTION DET

In the MOTION DET option, you can set the Motion Detection function, motion detection sensitivity, and the motion detection area. If you set the Motion Detection function, you can detect an intruder's movement and check it through the monitor and the ALARM OUT terminal.

☞ MIRROR : Horizontally flips the video output signal.

☞ D-ZOOM :Sets the magnification of the Digital Zoom.

The magnification level can be set to up to 10x.

☞ POSI/ NEGA : Outputs the video output signal normally or

If you set ALARM which is located under COLOR/BW AUTO menu to ON while MOTION DET remains ON, the ALARM output port can not send any motion.

inversely.

☞ ZOOM SPEED : In the ZOOM SPEED option, use the

LEFT and RIGHT buttons to set the speed as follows:

1 : Takes about 17 seconds from 1 x to 22 x magnification (slowest speed).

2 : Takes about 10 seconds from 1 x to 22 x magnification (slow speed).

3 : Takes about 6 seconds from 1 x to 22 x magnification (fast speed).

4 : Takes about 3 seconds from 1 x to 22 x magnification (fastest speed).

☞ DETAIL: Adjusts the sharpness.

(SET UP)
CAMERA ID	OFF
IRIS	ALC...
SHUTTER	OFF
AGC	LOW
WHITE BAL	ATW
SPECIAL	...	Press the
AUTO FOCUS	ONEAF
		ENTER
MOTION DET	ON...
PRESET	...		button.
COLOR/BW	COLOR
EXIT	QUIT

(MOTION DET)

AREA PRESET...

SENSITIVITY MEDIUM RET

23

24